This kit is designed to be used with DDF Revolve 400X Micro-Polishing System for professional microdermabrasion and deep cleansing.
Achieve professional results without a visit to a doctor's office or spa. This refill kit is designed to be used with your DDF 400X Micro-Polishing System for easy, gentle and effective microdermabrasion and deep cleansing at home.
· Gently polishes away surface imperfections
· Instantly reduces the appeance of fine lines and pores, while improving skin tone and evenness
· 8 x better exfoliation than a scrub alone
Directions For Use:
MICRODERMABRASION TREATMENT:
Cleanse skin as normal.
While skin is still wet, attach the Foam Exfoliator to the DDF Micro-Polisher.
Apply a thin layer (about ½ teaspoon) of DDF Polishing Crystals over the face.
Turn on the DDF Micro-Polisher starting with the lower speed setting and gradually increase to the higher speed setting based on skin sensitivity.
Gently massage the Foam Exfoliator over the face using small circular motions for approximately one (1) minute avoiding the eye area and hair line. As the crystals activate, it is normal to experience a warming sensations.
After polishing is complete, rinse face and wash Foam Exfoliator with water and antibacterial soap.
DUE TO THE PROFESSIONAL LEVEL OF EXFOLIATION, WE RECOMMEND PERFORMING THE MICRODERMABRASION TREATMENT NO MORE THAN TWO TIMES A WEEK, ON NON-CONSECUTIVE DAYS.
DEEP CLEANSING:
Attach Deep Cleansing Brush to the DDF Micro-Polisher.
Moisten face with water and apply your favorite DDF cleanser to the Deep Cleansing Brush or directly to face.
Turn on the DDF Micro-Polisher at desired speed level.
Massage the Deep Cleansing Brush over the face using small circular motions for approximately one (1) minute avoiding the eye area and hair line.
When cleansing is complete, rinse face and wash brush attachment with water and antibacterial soap.
Deep cleansing should only be performed once daily and only on days when you are not using the Foam Exfoliator and DDF Polishing Crystals.
INSTALLING BATTERIES:
Gently rock the battery compartment at the bottom of the handle side by side while pulling to release the battery cover.
Insert 2 AA batteries (included) aligning +/- symbols. The +/- symbols are found on the inside of the cap.
Replace battery cover.
Replace batteries as needed.
Do not mix old and new batteries as unit may become damaged.
Ingredients:
DDF POLISHING CRYSTAL INGREDIENTS:
PEG-8, SODIUM BICARBONATE, SILICA SILYLATE, POLYSORBATE 20, NIACINAMIDE, TOCOPHERYL ACETATE, ASCORBIC ACID.
